Joe’s Seaduck Laying out the wing pieces. Test fitting nacelles. Gluing on nacelles. Aileron servos installed. Adding the “deck”. Pontoons added, pontoons and top and bottom half of fuselage not yet glued together. Finalizing and organizing wiring. Halves glued together. Getting ready to paint, motors taped off. Another angle. Nacelle side of the damage. Gluing a nacelle. Stacked two 1x4s and clamped them to the table to make a 90 degree tool. Fuselage added to wing. Horizontal and vertical stabilizers added. Starting the fuselage. Set wing and top half of fuselage on bottom. Soldering battery extensions. Preparing to glue the bottom half to the top half. Pontoons added. Bottom painted. Wing torn off. Nose pushed in. Wing side of the damage.Share this:FacebookXLike this:Like Loading...